13VAC5-63 Virginia Uniform Statewide Building Code

REGULATIONS

Vol. 27 Iss. 12 - February 14, 2011

TITLE 13. HOUSING

BOARD OF HOUSING AND COMMUNITY DEVELOPMENT

Chapter 63

Final Regulation

REGISTRAR'S NOTICE: The following regulations of the Board of Housing and Community Development are exempt from the Administrative Act pursuant to § 2.2-4006 A 12 of the Code of Virginia; however, the regulations are subject to the provisions of § 2.2-4007.06 concerning public petitions. The regulations were (i) published as final regulations in 27:2 VA.R. 217-342 September 27, 2010, (ii) suspended pursuant to § 2.2-4007.06 in 27:6 VA.R. 663-664 November 22, 2010; and (iii) readopted as final regulations with the changes shown in brackets below.

Title of Regulation: 13VAC5-63. Virginia Uniform Statewide Building Code (amending 13VAC5-63-210, 13VAC5-63-240, 13VAC5-63-245.

Statutory Authority: § 36-98 of the Code of Virginia.

Effective Date: March 1, 2011.

Agency Contact: Stephen W. Calhoun, Regulatory Coordinator, Department of Housing and Community Development, Main Street Center, 600 East Main Street, Suite 300, Richmond, VA 23219, telephone (804) 371-7000, FAX [phone], TTY [phone], or email [e-mail].

Summary:

The Virginia Uniform Statewide Building Code (USBC) governs the construction, maintenance, and rehabilitation of new and existing building and structures. The USBC uses nationally recognized model building codes and standards produced by the International Code Council and other standard-writing groups as the basis for the technical provisions of the regulation. Every three years, new editions of the model codes become available. At that time, the Board of Housing and Community Development initiates a regulatory action to incorporate the newest editions of the model codes into the regulation. Those affected by the regulation then review the proposed regulation to assure that the newest model code and its referenced standards reflect the minimum standards necessary for the safety of existing buildings and property. After the publishing of the proposed regulation, the board establishes a comment period for the acceptance of code change proposals to modify the model code or standards or any provisions of the entire regulation. Code change proposals are assimilated into a compilation document containing a staff evaluation of each proposal and the compilation document is reviewed by client groups during a second comment period and additional comment on each proposal is accepted. A public hearing is also held. The board then considers all comments on all proposals and develops a final regulation to complete the regulatory process.

Final regulations for the USBC were published in Volume 27, Issue 2 of the Virginia Register of Regulations on September 27, 2010 (27:2 VA.R. 217-342 September 27, 2010), initiating a 30-day comment period. During the comment period, a number of petitions were received concerning substantive changes between the proposed and final regulations. The board suspended the regulatory process on certain provisions (refer to 27:6 VA.R. 663-664 November 22, 2010) and established an additional 30-day comment period for the submittal of additional public comments on the petitioned provisions.

On January 24, 2011, the Board of Housing and Community Development considered the public comment on the petitioned provisions. The board readopted 13VAC5-63-210 M 68 and M 69, 13VAC5-63-240 E and Q, and 13VAC5-63-245 B as the final regulations were published; and readopted 13VAC5-63-240 L with the following changes from the final regulations:

13VAC-63-240 L. Item 1 of Section 906.1 of the International Building Code was amended to return to the language published in the proposed regulation that permits fire extinguishers to be omitted in the common areas of buildings of Groups A, B, and E that are equipped throughout with quick response sprinklers. This language is consistent with the language in the 2009 edition of the International Building Code.

13VAC5-63-210. Chapter 3 Use and occupancy classification.

***

68. Change Section E3802.4 to read:

E3802.4 In unfinished basements. Where type SE or NM cable is run at angles with joists in unfinished basements, cable assemblies containing two or more conductors of sizes 6 AWG and larger and assemblies containing three or more conductors of sizes 8 AWG and larger shall not require additional protection where attached directly to the bottom of the joists. Smaller cables shall be run either through bored holes in joists or on running boards. NM cable installed on the wall of an unfinished basement shall be permitted to be installed in a listed conduit or tubing or shall be protected in accordance with Table E3802.1. Conduit or tubing shall be provided with a suitable insulating bushing or adapter at the point the where cable enters the raceway. The NM or SE cable sheath shall extend through the conduit or tubing and into the outlet or device box not less than 1/4 inch (6.4 mm). The cable shall be secured within 12 inches (305 mm) of the point where the cable enters the conduit or tubing. Metal conduit, tubing, and metal outlet boxes shall be connected to an equipment grounding conductor.

69. Change Section E3902.11 to read:

E3902.11 Arc-fault protection of bedroom outlets. All branch circuits that supply 120-volt, single phase, 15-ampere and 20-ampere outlets installed in bedrooms shall be protected by a combination type arc-fault circuit interrupter installed to provide protection of the branch circuit.

Exceptions:

1. Where a combination AFCI is installed at the first outlet to provide protection for the remaining portion of the branch circuit, the portion of the branch circuit between the branch-circuit overcurrent device and such outlet shall be wired with metal outlet and junction boxes and RMC, IMC, EMT or steel armored cable, Type AC meeting the requirements of Section E3908.8.

2. AFCI protection is not required for a branch circuit supplying only a fire alarm system where the branch circuit is wired with metal outlet and junction boxes and RMC, IMC, EMT or steel armored cable Type AC meeting the requirements of Section E3908.8.

13VAC5-63-240. Chapter 9 Fire protection systems.

***

E. Change Section 903.2.3 of the IBC to read:

903.2.3 Group E. An automatic sprinkler system shall be provided for Group E occupancies as follows:

1. Throughout all Group E fire areas greater than 20,000 square feet (1858 m²) in area.

2. Throughout every portion of educational buildings below the lowest level of exit discharge serving that portion of the building.

Exception: An automatic sprinkler system is not required in any area below the lowest level of exit discharge serving that area where every classroom throughout the building has at least one exterior exit door at ground level.

***

L. Change Item 1 of Section 906.1 of the IBC to read:

906.1 General. Portable fire extinguishers shall be provided in occupancies and locations as required by the International Fire Code.

1. In Group A, B, E, F, H, I, M, R-1, R-4, and S occupancies.

[ Exceptions Exception ]:

[ 1. ] Group R-2 occupancies [ In Group A, B, and E occupancies equipped throughout with quick response sprinklers, portable fire extinguishers shall be required only in locations specified in Items 2 through 6.

2. ] In Group I-3 occupancies, portable fire extinguishers shall be permitted to be located at staff locations and the access to such extinguishers shall be permitted to be locked.

***

Q. Change Section 911.1.3 of the IBC to read:

911.1.3 Size. The fire command center shall be a minimum of 96 square feet (9 m²) in area with a minimum dimension of eight feet (2438 mm).

Exception: Where it is determined by the building official, after consultation with the fire chief, that specific building characteristics require a larger fire command center, the building official may increase the minimum required size of the fire command center up to 200 square feet (19 m²) in area with a minimum dimension of up to 10 feet (3048 mm).

***

13VAC5-63-245. Chapter 10 Means of egress.

***

B. Change Section 1005.1 of the IBC to read:

1005.1 Minimum required egress width. The means of egress width shall not be less than required by this section. The total width of means of egress in inches (mm) shall not be less than the total occupant load served by the means of egress multiplied by 0.3 inches (7.62 mm) per occupant for stairways and by 0.2 inches (5.08 mm) per occupant for other egress components. The width shall not be less than specified elsewhere in this code. Multiple means of egress shall be sized such that the loss of any one means of egress shall not reduce the available capacity to less than 50% of the required capacity. The maximum capacity required from any story of a building shall be maintained to the termination of the means of egress.

Exceptions:

1. Means of egress complying with Section 1028.

2. For occupancies other than Groups H-1, H-2, H-3, H-4 and I-2, in buildings equipped with an automatic sprinkler system installed in accordance with Section 903.3.1.1 or 903.3.1.2, the total width of means of egress in inches (mm) shall not be less than the total occupant load served by the means of egress multiplied by 0.2 inches (5.08 mm) per occupant for stairways and by 0.15 inches (3.81 mm) per occupant for other egress components.

***

VA.R. Doc. No. R09-1894; Filed January 25, 2011, 2:44 p.m.