 |
Virginia Administrative Code (Last Updated: January 10, 2017) |
 |
Title 9. Environment |
|
Agency 5. State Air Pollution Control Board |
|
Chapter 40. Existing Stationary Sources |
Section 4040. Control technology guidelines
-
A. Sheet basecoat (exterior and interior) and overvarnish; two-piece can exterior (basecoat and overvarnish). The control technology should consist of one or more of the following:
1. Use of electrodeposited waterborne coatings;
2. Use of ultraviolet coatings;
3. Use of high solids coatings;
4. Carbon adsorption; and
5. Incineration; or
6. Any technology of equal or greater control efficiency when compared to the use of coating complying with 9VAC5-40-4030 A 1, provided such technology is approved by the board.
B. Two-piece and three-piece can interior body spray; two-piece can exterior end (spray or roll coat). The control technology should consist of one or more of the following:
1. Use of waterborne coatings;
2. Use of powder coatings;
3. Use of high-solids coatings;
4. Carbon adsorption; and
5. Incineration; or
6. Any technology of equal or greater control efficiency when compared to the use of coating complying with 9VAC5-40-4030 B 1, provided such technology is approved by the board.
C. Three-piece can side-seam spray. The control technology should consist of one or more of the following:
1. Use of waterborne coatings;
2. Use of powder coatings; and
3. Use of high solids coatings; or
4. Any technology of equal or greater control efficiency when compared to the use of coating complying with 9VAC5-40-4030 C 1, provided such technology is approved by the board.
D. End sealing compound coating. The control technology should consist of one or more of the following:
1. Use of waterborne coatings;
2. Use of high-solids coatings; or
3. Any technology of equal or greater control efficiency when compared to the use of coating complying with 9VAC5-40-4030 D 1, provided such technology is approved by the board.
Historical Notes
Derived from VR120-04-2904, eff. July 1, 1991.