Section 170. Contingency plan requirements and approval

Part IV. Oil Discharge Contingency Plan (ODCP) Requirements

A. Section 62.1-44.34:15 of the Code of Virginia requires that all facility oil discharge contingency plans must conform to the requirements and standards determined by the board to be necessary to ensure that the applicant can take such steps as are necessary to protect environmentally sensitive areas; to respond to the threat of an oil discharge; and to contain, cleanup, and mitigate an oil discharge within the shortest feasible time. Each such plan shall provide for the use of the best available technology (economically feasible, proven effective and reliable and compatible with the safe operation of the facility) at the time the plan is submitted for approval and, in order to be approvable, shall contain, at a minimum, the following requirements:

1. The name of the facility, geographic location and access routes from land and water if applicable;

2. The names of the operators of the facility including address and phone number;

3. A physical description of the facility consisting of a plan of the facility which identifies the applicable oil storage areas, transfer locations, control stations, above and below ground oil transfer piping within the facility boundary (and including adjacent easements and leased property), monitoring systems, leak detection systems and location of any safety protection devices;

4. A copy of the material safety data sheet (MSDS) or its equivalent for each oil or groups of oil with similar characteristics stored, transferred or handled at the facility. To be equivalent, the submission shall contain the following:

a. Generic or chemical name of the oil;

b. Hazards involved in handling the oil; and

c. A list of fire-fighting procedures and extinguishing agents effective with fires involving each oil or groups of oil demonstrating similar hazardous properties which require the same fire-fighting procedures;

5. The maximum storage or handling capacity of the facility and the individual tank capacities or, in the case of a pipeline, the average daily throughput of oil;

6. A complete listing, including 24-hour phone numbers, of all federal, state and local agencies required to be notified in the event of a discharge;

7. The position title of the individuals responsible for making the required notifications and a copy of the notification check-off list;

8. The position title, address and phone number of the individuals authorized to act on behalf of the operator to implement containment and cleanup actions. This individual shall be available on a 24-hour basis to ensure the appropriate containment and cleanup actions are initiated;

9. The position title of the individuals designated by the operator to ensure compliance during containment and cleanup of a discharge with applicable federal, state and local requirements for disposal of both solid and liquid wastes;

10. Identification and assurance by contract or other means acceptable to the board of the availability of private personnel and equipment necessary to remove to the maximum extent practicable the worst case discharge and to mitigate or prevent a substantial threat of such a discharge. This contract or agreement shall ensure a certain response within the shortest feasible time. The board will accept a letter of understanding between the operator and the response contractors which attests to this capability being readily available. Membership in a cleanup cooperative or other response organization is also acceptable. A listing of contractor or cooperative capabilities, including an inventory of the equipment and specification of the other information required by subdivision 12 of this subsection, shall be included unless these capabilities are already on file with the department;

11. Assessment of the worst case discharge, including measures to limit the outflow of oil, response strategy and operational plan. For the purpose of this chapter, the worst case discharge is the instantaneous release of the volume of the largest tank on the facility (125% of the volume of the largest tank for facilities with multiple tanks within a single containment dike) during adverse weather conditions. Facilities shall take into consideration that due to hydraulic pressure of the release, the secondary containment will not contain this volume in its entirety. The worst case discharge for a pipeline shall be based upon the volume of a discharge calculated using the maximum pressure, velocity, and elevation, and the largest pipe size and pipeline location. If facility design and operation indicates that this worst case discharge scenario does not meet the intent of this chapter, the board may require submission of other worst case scenarios on a facility-specific basis;

12. Inventory of facility containment equipment, including specification of quantity, type, location, time limits for gaining access to the equipment, and identification of facility personnel trained in its use;

13. Identification and location of natural resources at risk (including, but not limited to, surface waters as indicated on the applicable USGS quadrangle maps, groundwater, public water supplies, public and private water wells and springs, state or federal wildlife management areas, wildlife refuges, management areas, sanctuaries, property listed on the National Register of Historic Places and property listed on the National Register of Natural Landmarks), priorities for protection and means of protecting these resources;

a. In addition to the requirements set forth in this subdivision, the operator of a facility with an aggregate aboveground storage or handling capacity of one million gallons or greater of oil shall conduct a groundwater characterization study (GCS) within the geographic boundaries of the facility to be submitted as part of the contingency plan. The operator of such a facility shall utilize upgradient and downgradient GCS monitoring wells to satisfy this requirement. At the time of a discharge, the operator of such a facility shall conduct further characterization of the groundwater as required by the board;

b. For purposes of satisfying the requirement to identify and locate natural resources at risk, the operator of a pipeline shall identify surface waters as indicated on the applicable USGS quadrangle maps, public water supplies, state or federal wildlife management areas, wildlife refuges, management areas, sanctuaries, property listed on the National Register of Historic Places and property listed on the National Register of Natural Landmarks which could reasonably be expected to be impacted by the discharge. At the time of a discharge, the operator of a pipeline shall conduct a complete groundwater characterization study as required by the board and identify other natural resources at risk including public and private wells or springs which could reasonably be expected to be impacted by the discharge;

14. Identification and location of any municipal or other services (including, but not limited to, storm drains, storm water collection systems and sanitary sewer systems) at risk, notification procedures applicable and means of protection of these services. The identification and location of all municipal services shall include those services for which official records are available. The operator of a pipeline shall determine which sections of the system are located in areas that would require an immediate response by the operator to prevent hazards to the public if a discharge occurred;

15. If applicable, the facility's responsibility for responding to a discharge from a vessel moored at the facility and the identity of the sizes, types, and number of vessels that the facility can transfer oil to or from simultaneously;

16. A description of training, equipment testing, and periodic unannounced oil discharge drills conducted by the operator to mitigate or prevent the discharge or the substantial threat of a discharge;

17. The facility's oil inventory control procedures. Facilities shall ensure that this control procedure is capable of providing for the detection of a discharge of oil within the shortest feasible time in accordance with recognized engineering practices and industry measurement standards;

18. A detailed description of a system for early detection of a discharge to groundwater, utilizing upgradient and downgradient leak detection monitoring wells or other groundwater protection measures acceptable to the board (i.e., visual, interstitial, vapor and leak detection groundwater monitoring wells). The system will be operated, maintained and monitored in the manner approved and be subject to inspection by the department under the pollution prevention requirements of Part III (9VAC25-91-130 et seq., Pollution Prevention Requirements) of this chapter. Operators subject to subdivision 13 a of this subsection may utilize such GCS wells to meet this requirement when approved by the board;

19. The procedures to be followed, upon detection of a discharge of oil, for testing and inspection of all tanks, piping and all oil transfer associated equipment that could reasonably be expected to be a point source for the discharge. These procedures shall be conducted within the shortest feasible time, include a progression of written procedures from visual inspection to formal testing and be conducted in accordance with recognized engineering practices;

20. The facility's preventive maintenance procedures applicable to the critical equipment of an oil storage and transfer system as well as the maximum pressure for each oil transfer system. The term "critical equipment" shall mean equipment that affects the safe operation of an oil storage and handling system;

21. A description of the security procedures used by facility personnel to avoid intentional or unintentional damage to the facility; and

22. A post-discharge review procedure to assess the discharge response in its entirety.

B. All nonexempt facility operators shall file with the board the application form for approval of the contingency plan. This form shall be submitted with the required contingency plan and shall be completed insofar as it pertains to the facility. The operator shall sign and date the certification statement on the application form. If the operator is a corporation, the form shall be signed by an authorized corporate official; if the operator is a municipality, state, federal or other public agency, the form shall be signed by an authorized executive officer or ranking elected official; if the operator is a partnership or sole proprietorship, the form shall be signed by a general partner or the sole proprietor. All forms shall be acknowledged before a Notary Public.

C. Contingency plans shall be filed with and approved by the board. The plan shall be submitted to the board at the address specified in 9VAC25-91-60 A. A copy of the original with the facility-specific information and the approval letter shall be retained at the facility and shall be readily available for inspection.

D. An operator of multiple facilities may submit a single contingency plan encompassing more than one facility if the facilities are located within the defined boundaries of the same city or county or if the facilities are similar in design and operation. The plan shall contain site-specific information as required by subsection A of this section for each facility. The site-specific information shall be placed in appendices to the plan.

Upon renewal of an approved contingency plan submitted under this subsection, the board shall consider the individual facilities subject to all provisions of subsections E through J of this section.

E. Oil discharge contingency plans shall be reviewed, updated if necessary and resubmitted to the board for approval every 60 months from the date of approval unless significant changes occur sooner. Operators shall notify the board of significant changes and make appropriate amendments to the contingency plan within 30 days of the occurrence. For the purpose of this chapter, a significant change includes the following:

1. A change of operator of the facility;

2. An increase in the maximum storage or handling capacity of the facility that would change the measures to limit the outflow of oil, response strategy or operational plan in the event of the worst case discharge;

3. A decrease in the availability of private personnel or equipment necessary to remove to the maximum extent practicable the worst case discharge and to mitigate or prevent a substantial threat of such a discharge;

4. A change in the type of product dealt in, stored or handled by any facility covered by the plan for which a MSDS or its equivalent has not been submitted as part of the plan; or

5. A change in the method or operation utilized for the early detection of a discharge to groundwater (i.e., change in a method of leak detection).

F. Updated plans or certification for renewal of an existing plan shall be submitted to the board for review and approval not less than 90 days prior to expiration of approval of the current plan. Submittal of the certification for renewal for an existing plan shall be made in accordance with the provisions of subsection B of this section. All notifications of changes, renewals, submissions and updates of plans required by this chapter shall be directed to the respective regional office.

G. An oil discharge exercise may be required by the board to demonstrate the facility's ability to implement the contingency plan. The board will consult with the operator of the facility prior to initiating an exercise. Where appropriate, the board will ensure coordination with federal agencies prior to initiation of an exercise.

H. The board may, after notice and opportunity for a conference pursuant to § 2.2-4019 of the Code of Virginia, deny or modify its approval of an oil discharge contingency plan if it determines that:

1. The plan as submitted fails to provide sufficient information for the board to process, review and evaluate the plan or fails to ensure the applicant can take such steps as are necessary to protect environmentally sensitive areas, to respond to the threat of a discharge, and to contain and clean up an oil discharge within the shortest feasible time;

2. A significant change has occurred in the operation of the facility covered by the plan;

3. The facility's discharge experience or its inability to implement its plan in an oil spill discharge exercise demonstrates a necessity for modification; or

4. There has been a significant change in the best available technology since the plan was approved.

I. The board, after notice and opportunity for hearing, may revoke its approval of an oil discharge contingency plan if it determines that:

1. Approval was obtained by fraud or misrepresentation;

2. The plan cannot be implemented as approved;

3. A term or condition of approval of this chapter has been violated; or

4. The facility is no longer in operation.

J. A Facility Response Plan (FRP) developed pursuant to § 4202 of the federal Oil Pollution Act of 1990, Pub. L. No. 101-380, 33 USCA § 2716 (1996), may be accepted as meeting the requirements of subdivisions A 1 through A 22 of this section. The operator shall submit a copy of the FRP and a copy of the currently valid FRP approval letter for the facility for review and approval by the board. The FRP shall contain a cross reference in order to index pages for the specific requirements of the ODCP. The FRP shall also contain the satisfaction of the requirements of subdivisions A 13 a and A 18 of this section. This information shall be resubmitted in accordance with the renewal period established by federal statute or regulation but in no instance shall the renewal period exceed five years. The board shall be notified of any plan amendments within 30 days of the amendment.

Historical Notes

Derived from Volume 14, Issue 18, eff. June 24, 1998; Errata, 14:23 VA.R. 3682 August 3, 1998; amended, Virginia Register Volume 31, Issue 26, eff. November 1, 2015.

Statutory Authority

§§ 62.1-44.15, 62.1-44.34:15, 62.1-44.34:15.1 and 62.1-44.34:19.1 of the Code of Virginia.